Hey guys I hope this is the correct section to post so here goes.
I bought an HID setup for my aftermarket foglights yesterday and installed drivers side. Turned on my lights to test and see the difference and they turned on for about 2 seconds there was a pop noise and then it went out. So now both foglights are out and the switch on the dash doesn't light up. I obviously thought fuse right off since our stock foglight fuse is a 10 I replaced out with another 10 to check and nothing happened so I swapped a 15 in and still nothing. I need a few serious suggestions, the dealer wants 110 to just look at it if you guys could help me i'd appreciate it.
Thanks Widebodytiburon
I bought an HID setup for my aftermarket foglights yesterday and installed drivers side. Turned on my lights to test and see the difference and they turned on for about 2 seconds there was a pop noise and then it went out. So now both foglights are out and the switch on the dash doesn't light up. I obviously thought fuse right off since our stock foglight fuse is a 10 I replaced out with another 10 to check and nothing happened so I swapped a 15 in and still nothing. I need a few serious suggestions, the dealer wants 110 to just look at it if you guys could help me i'd appreciate it.
Thanks Widebodytiburon