okay, so when i got the car, i got the PO501 code which was vehicle speed sensor performance. so months later i got a new sensor that was off of a 2006 tiburon (non-abs) i had to chip out the old sensor becuase it got seized up in the hub... well anyways i installed the other sensor hoping it would clear the code and get rid of my 5000rpm limit.. for a few hours the code went off and everything worked good.. then a different code "A Range speed sensor" so now i have the cel again, which comes and goes every 40 to 60 miles. and i still have the 5k limit. so my question is should i replace the hub?the sensor is still pretty new. but i was told if you get a new sensor, you have to replace the hub becuase the relucter ring will have a different resistance because of the old sensor? please help haha. ive tried to fix it, and it is rather annoying.. thanks for any help. also i have tested the transmission speed sensor just to see if that was setting the code. but i got a good reading and signal..
↧