Hey guys, I was wondering if you could assist me with some basic information.
I just got my new Headlights! These 05-06 headlights are designed to be fitted on my 03 GK. They look wicked and I couldn't be happier with their looks. Before I install them though, I am waiting for my CCFL Angel-Eyes + switch to arrive for installation.
![]()
However, I wanted to test these babies out and plugged one of them in. I found a couple issues unfortunately. My Tiburon (In Aus) do not have matching receivers. My hold these:
- One 6 pin female receiver
- One 2 pin female receiver
Meanwhile, the new headlights provides the following:
- One 4 pin male receiver that can fit and get the headlights/high beams working regardless but unsure if I will be missing power or a vital function without the perfect connection and
- One 3 pin male receiver
So with the connection of the 6 into the 4, I can get the headlights and high beams to run. However my parkers nor my blinkers work (other receiver cannot fit).
So I am basically asking, how can I go about changing the receivers to the adequate pins? Is it something I can simply buy from the appropriate store and DIY install them easily enough? Or do I require a specific piece only provided by limited suppliers? Or is there an alternative route?
As usual thanks for the assistance guys! + Rep for help :D
First Picture: Both the 6 pin and 2 pin female receivers
Second Picture: 4 pin male receiver
Third Picture: 3 pin male receiver
I just got my new Headlights! These 05-06 headlights are designed to be fitted on my 03 GK. They look wicked and I couldn't be happier with their looks. Before I install them though, I am waiting for my CCFL Angel-Eyes + switch to arrive for installation.
However, I wanted to test these babies out and plugged one of them in. I found a couple issues unfortunately. My Tiburon (In Aus) do not have matching receivers. My hold these:
- One 6 pin female receiver
- One 2 pin female receiver
Meanwhile, the new headlights provides the following:
- One 4 pin male receiver that can fit and get the headlights/high beams working regardless but unsure if I will be missing power or a vital function without the perfect connection and
- One 3 pin male receiver
So with the connection of the 6 into the 4, I can get the headlights and high beams to run. However my parkers nor my blinkers work (other receiver cannot fit).
So I am basically asking, how can I go about changing the receivers to the adequate pins? Is it something I can simply buy from the appropriate store and DIY install them easily enough? Or do I require a specific piece only provided by limited suppliers? Or is there an alternative route?
As usual thanks for the assistance guys! + Rep for help :D
First Picture: Both the 6 pin and 2 pin female receivers
Second Picture: 4 pin male receiver
Third Picture: 3 pin male receiver