Hi all,
Just found some Headers on eBay UK, the item number is: 320994037296
Now I was thinking of going down the road of getting a custom made header and cat back, but this header has the primary pipe diameter that I was thinking of getting (1.5") and the diameter of the collector is roughly right, I was looking to go 2.25" all the way through, but moving from a 2" flexi pipe to a 2.25" cat back should be ok.
(To mention, I am looking for low to mid-range torque which is why these headers interest me)
Firstly, do you think they're a bargain or cheap?
Secondly, should fitting a cat be easy enough?
Thirdly, are the primary pipes too short for torque? With custom made ones I was thinking of getting slightly longer primary tubes ...
Just found some Headers on eBay UK, the item number is: 320994037296
Now I was thinking of going down the road of getting a custom made header and cat back, but this header has the primary pipe diameter that I was thinking of getting (1.5") and the diameter of the collector is roughly right, I was looking to go 2.25" all the way through, but moving from a 2" flexi pipe to a 2.25" cat back should be ok.
(To mention, I am looking for low to mid-range torque which is why these headers interest me)
Firstly, do you think they're a bargain or cheap?
Secondly, should fitting a cat be easy enough?
Thirdly, are the primary pipes too short for torque? With custom made ones I was thinking of getting slightly longer primary tubes ...