Recently installed this gauge on my fuel line. Been holding up fine for about a week now but today I smelled fuel and the gauge was turn in a different position ,it came loose from the vibrations (not from the elbow I attached to it ,that has thread locker) . It came loose from the fitting coming out the backe of the gauge . I figure just unscrew it and and put thread locker on. When I tried this I felt the whole gauge coming apart,even some of the liquid started to leak out. When I tighten it by hand it stops leaking .any way to fix this? If I unscrew the fitting out the back with the gauge fall apart? It felt like it was...
![]()
