1) Where is the best place to buy a set of Wiseco rings for my 82.5mm pistons? Or is there another way other than going with Wisecos?
2) Do the Wiseco piston pins are a direct fit on the OEM rod?
Due to a recent cylinder head removal I've decided to install a set of Wiseco pistons I had laying around making sure that the engine will be ready for MOAAR POWAAAAA with boost.
3) Will the oil holes on the crankshaft need chamfering likethis??? Don't know if ours are already chamfered but would the "notch-like chamfering" hurt? specially for raising the rev limiter to 7000+RPMs?
2) Do the Wiseco piston pins are a direct fit on the OEM rod?
Due to a recent cylinder head removal I've decided to install a set of Wiseco pistons I had laying around making sure that the engine will be ready for MOAAR POWAAAAA with boost.
3) Will the oil holes on the crankshaft need chamfering likethis??? Don't know if ours are already chamfered but would the "notch-like chamfering" hurt? specially for raising the rev limiter to 7000+RPMs?