I know this is going to sound like a stupid question but I just got my '05 SE from a friend with only 42k on it and it is in prime condition. Im installing an interior neon kit in it and i need to run some wiring below the paneling on the floor connected to the door frame. i see two plastic caps on both sides but when i slide my knife up in there to try to pop 'em out they just ply and dont pop. im afraid to break them and have my new baby look like s*** can anybody help?
Do i just slide a flathead in there and pry till they pop out? ive read a lot of DIY posts on here stating that to get a lot of the interior out you have to pry on it like a mother f*****. if someone could lend me some advice quick itd be greatly appreciated i wanna get back out there and start working on it again at day break
Thanks, and I am stoked to be part of the community!!!
Axel B.
Do i just slide a flathead in there and pry till they pop out? ive read a lot of DIY posts on here stating that to get a lot of the interior out you have to pry on it like a mother f*****. if someone could lend me some advice quick itd be greatly appreciated i wanna get back out there and start working on it again at day break
Thanks, and I am stoked to be part of the community!!!
Axel B.