Today i went to install my Stage 3 Spec that I ordered and ran into a couple issues... First, the disk doesn't want to slide onto the spline in the trans... I've read about people filing it down to make it fit, and just wanted to ask and be sure that is the best way to handle it (better than dealing with customer service from what I've heard).....
And the second issue is that when I put the pressure plate onto the flywheel (CM flywheel), the holes in the pressure plate seemed just a little bit too small to let the peg pieces slide in... I can easily drill them out and make it all fit, i just wanted to make sure that's the correct way to approach this issue...
And the second issue is that when I put the pressure plate onto the flywheel (CM flywheel), the holes in the pressure plate seemed just a little bit too small to let the peg pieces slide in... I can easily drill them out and make it all fit, i just wanted to make sure that's the correct way to approach this issue...